Monthly Archives: October 2012

Tub floor and rear chassis

Following removal of the tub floor for it to be sent away to be used as a pattern by Bits4Landys to create a replacement panel, I have taken the opportunity to carry out some work on the rear chassis. The roll cage that was fitted had some support posts welded to the top of the chassis, […]

Rate this:

Bulkhead top section strip down

In prep for exchanging my rotten bulkhead top section for a nice shiney galvanised refurbished item, I spent an hour or so today stripping my old down and removing evenything fitted to it.

Rate this:

Bulhead top section strip out

Last week (14th) saw the start of work on the bulkhead.  The main (lower) bulkhead appears fine.  But it’s a different story with the top section. As can be seen in the photos, the bottom flange of the top section is pretty corroded. My options?  Strip and repair the top section or buy a replacement.  […]

Rate this: